Change Log

Bug Fixes

• Firmware Server
  Updated the default firmware download server to use a secure HTTPS connection, improving the reliability and security of firmware downloads.

• Automation Toggle
  Improved the automation toggle label so it now accurately reflects the active mode: Auto Framing in Framing mode and Auto Tracking in Tracking mode.

• NDI® Settings Validation Message
  Improved the field requirement error message on the NDI Settings page for clearer configuration guidance.

• Hardware Stability Fix
  Improved system stability to help prevent certain cameras from unexpectedly reverting to factory default settings.

Known Issues

1. Network Reset - NTP Settings
   NTP settings do not revert to default values after performing a Network Reset.

2. VISCA Power Command/Standby Limitation
   After placing the camera into Standby using the VISCA Power Off command or the IR remote, the camera cannot be powered back on using VISCA over IP.

1. The IR Remote and Serial VISCA commands are unaffected and can power the camera back on.

3. H.265 Encoding Display Mismatch
   When any stream (PTZ Stream, Reference Stream, or Stream 3) is set to H.265, all streams output H.265. However, the Web UI does not update the Encoding Profile field for the Reference Stream or Stream 3 accordingly.

4. Reboot - Password Creation Prompt
   In rare cases, after rebooting via the Web UI, the new Password Creation prompt may appear unexpectedly and generate an error if a new password is entered.

1. Workaround: Refresh the page to clear the prompt and log in normally.